Mostrando postagens com marcador ATR-72. Mostrar todas as postagens
Mostrando postagens com marcador ATR-72. Mostrar todas as postagens

sexta-feira, 17 de fevereiro de 2023

NEPAL - YETI AIRLINES 9N-ANC ATR 72-212A - NO ENGINES POWER

 




Source: Preliminary Report


On 15 January 2023, an ATR 72-212A was operating scheduled flights between Kathmandu (VNKT) and Pokhara International Airport (VNPR). The same flight crew operated two sectors between VNKT to VNPR and VNPR to VNKT earlier in the morning. The accident occurred during a visual approach for runway 12 at VNPR. This was the third flight by the crew members on that day. The flight was operated by two Captains, one Captain was in the process of obtaining aerodrome familarization for operating into Pokhara and the other Captain being the instructor pilot. The Captain being familarized, who was occupying the left hand seat, was the Pilot Flying (PF) and the instructor pilot, occupying the right hand seat, was the Pilot Monitoring (PM). 1.1.2 The take-off, climb, cruise and descent to Pokhara was normal. During the first contact with Pokhara tower the Air Traffic Controller (ATC) assigned the runway 30 to land. But during the later phases of flight crew requested and received clearance from ATC to land on Runway 12.

At 10:51:36, the aircraft descended (from 6,500 feet at five miles away from 

VNPR and joined the downwind track for Runway 12 to the north of the runway. 

The aircraft was visually identified by ATC during the approach. At 10:56:12, 

the pilots extended the flaps to the 15 degrees position and selected the landing 

gears lever to the down position. The take-off (TO) setting was selected on 

power management panel.


At 10:56:27, the PF disengaged the Autopilot System (AP) at an altitude of 721

feet Above Ground Level (AGL). The PF then called for “FLAPS 30” at 

10:56:32, and the PM replied, “Flaps 30 and descending”. The flight data 

recorder (FDR) data did not record any flap surface movement at that time. 

Instead, the propeller rotation speed (Np) of both engines decreased

simultaneously to less than 25%1 and the torque (Tq) started decreasing to 0%

which is consistent with both propellers going into the feathered condition2.

 

On the cockpit voice recorder (CVR) area microphone recording, a single Master 

Caution chime was recorded at 10:56:36. The flight crew then carried out the

“Before Landing Checklist” before starting the left turn onto the base leg. During 

that time, the power lever angle increased from 41% to 44%. At the point, Np

of both propellers were recorded as Non-Computed Data (NCD) in the FDR 

and the torque (Tq) of both engines were at 0%. When propellers are in feather, 

they are not producing thrust.

When both propellers were feathered, the investigation team observed that 

both engines of 9N-ANC were running flight idle condition during the event flight

to prevent over torque. As per the FDR data, all the recorded parameters 

related to engines did not show any anomaly. At 10:56:50 when the radio

altitude callout for five hundred feet3 was annunciated, another “click” sound 

was heard4. The aircraft reached a maximum bank angle of 30 degrees at this 

altitude. The recorded Np and Tq data remained invalid. The yaw damper 

disconnected four seconds later. The PF consulted the PM on whether to 

continue the left turn and the PM replied to continue the turn. Subsequently, 

the PF asked the PM on whether to continue descend and the PM responded 

it was not necessary and instructed to apply a little power. At 10:56:54, another 

click was heard, followed by the flaps surface movement to the 30 degrees

position.


When ATC gave the clearance for landing at 10:57:07, the PF mentioned twice 

that there was no power coming from the engines. At 10:57:11, the power 

levers were advanced first to 62 degrees then to the maximum power position.

It was followed by a “click” sound at 10:57:16. One second after the “click” 

sound, the aircraft was at the initiation of its last turn at 368 feet AGL, the high

pressure turbine speed (Nh) of both engines increased from 73% to 77%. 


It is noted that the PF handed over control of the aircraft to the PM at 10:57:18.

At 10:57:20, the PM (who was previously the PF) repeated again that there was 

no power from the engines. At 10:57:24 when the aircraft was at 311 feet AGL,

the stick shaker was activated warning the crew that the aircraft Angle of Attack 

(AoA) increased up to the stick shaker threshold.


At 10:57:26, a second sequence of stick shaker warning was activated when the aircraft banked towards the left abruptly. Thereafter, the radio altitude alert for two hundred feet was annunciated, and the cricket sound and stick shaker ceased. At 10:57:32, sound of impact was heard in the CVR. The FDR and CVR stopped recording at 10:57:33 and 10:57:35 respectively.





sábado, 7 de fevereiro de 2015

TransAsia Flight GE-235 ATR-72-600 No Altitude, No Time for Recovering Straight Horizontal Flight



Flight Crew Operations Manual
ENGINE FLAME OUT AT TAKE OFF

ALERT
An engine flame out may be recognized by:
1 - Sudden dissymmetry
2 - Torque decrease
3 - Rapid Inter Turbine Temperature decrease

PROCEDURE
UPTRIM ............................................................... CHECK
AUTOFEATHER .................................................... CHECK
BLEED FAULT LIGHT ............................................  CHECK LIT

At Acceleration Altitude
Power Lever ........................................................  Flight Idle
Condition Lever ...................... ………………………….  FEATHERED then FUEL SHUT OFF
BLEED ..................................................................  OFF if necessary

If no damage suspected

ENGINE RESTART IN FLIGHT PROCEDURE ..........  APPLY

If unsuccessful:

SINGLE ENGINE OPERATION PROCEDURE ........... APPLY

ENGINE RESTART IN FLIGHT

PROCEDURE
FUEL SUPPLY ......................................................... CHECK
CONDITION LEVER (IT IS THE FUEL LEVER) ............ FUEL SHUT OFF
POWER LEVER ................................. …………………..  FLIGHT IDLE

CAUTION: After Automatic Take off Power Control System (ATPCS) sequence
                   POWER MANAGEMENT rotary selector must be set to MAXIMUM CONTINOUS
                   position before engine restart in order to cancel propeller feathering.

ENGINE START rotary selector ................. ………….  START A & B
ENGINE ELECTRONIC CONTROL push button ........ RESET is necessary or DESELECT if FAULT persist
START push-button ...............................................  ON
AT 10% NH (High Pressure Spool Rotation Speed):
CONDITION LEVER .................................................  FEATHERED
RELIGHT .................................................................  MONITOR
CONDITION LEVER .................................................  AUTO
POWER LEVER ........................................................  ADJUST TO OTHER ENGINE
ENGINE START rotary selector ...............................  OFF/START ABORT
SYSTEMS affected ..................................................  RESTORE

Comments
- Engine relighting in flight is only guaranteed within the envelope and always necessitates starter    assistance
- The power may be restored immediately after relighting providing TOIL > O°C.
- Should the engine fail to light up within 10 seconds, select fuel to shut off, the ignition OFF and allow engine to be ventilated for 30 seconds minimum prior to making another attempt.
 
ENGINE FLAME OUT

Comments
- Shut down the engine is no immediate relight
- The causes of engine flame out can generally be divided into two categories:
  - External causes such as icing, very heavy turbulence, fuel mismanagement.
    Theses causes, which may affect both engines can generally be easy determined and an immediate relight can be attempt.
  - Internal causes which as engine stall or fails usually affect a single engine and are not so easily determined, In these cases, the engine is shut down then the cause of the flame out investigated. If it cannot be positively determined what caused the flame out, the need for engine restart should be evaluated against the risk of further engine damage or fire may result from aa restart attempt.
- If damage is suspected, as precautionary measure, the FIRE handle is pulled.

 - If neither engine starts
  CONDITION LEVER both ...................................... .. FEATHERED then FUEL SHUT OFF
  ENGINE START rotary selector .............................. OFF/START ABORT
  FUEL PUMPS .................................................. ……..OFF
  FORCED LANDING or DITCHING PROCEDURE ........ APPLY

   CAUTION: Do not select AVIONICS VENTILATION EXHAUST MODE to OVERBOARD