sexta-feira, 12 de abril de 2019

MCAS No Longer Repeats After 5 sec. If electronic Trim Inputs Are Made - B737-8 MAX


CLICK ON IMAGE FOR ENLARGEMENT VIEW

MCAS no longer repeats after 5 sec. if electronic trim inputs are made

Pilots always retain pitch control authority over MCAS input to stabilizer


Boeing emphasizes that the MCAS is not an anti-stall or stall-prevention system, as it often has been portrayed in news reports.
MCAS has three new layers of protection:

Compares inputs of both AOA sensors
Pilots always retain pitch control authority over MCAS input to stabilizer

MCAS no longer repeats after 5 sec. if electronic trim inputs are made

The new software load [P12.1] has triple-redundant filters that prevent one or both angle-of-attack (AOA) systems from sending erroneous data to the FCCs that could falsely trigger the MCAS. It also has design protections that prevent runaway horizontal stabilizer trim from ever overpowering the elevators. Boeing showed pilots that they can always retain positive pitch control with the elevators, even if they don’t use the left and right manual trim wheels on the sides of the center console to trim out control pressures after turning off the trim cut-out switches.

Most important, the MCAS now uses both left and right AOA sensors for redundancy, instead of relying on just one. The FCC P12.1’s triple AOA validity checks include an average value reasonability filter, a catastrophic failure low-to-high transition filter and a left versus right AOA deviation filter. If any of these abnormal conditions are detected, the MCAS is inhibited.
Three secondary protections are built into the new software load. First, the MCAS cannot trim the stabilizer so that it overpowers elevator pitch control authority. The MCAS nose-down stab trim is limited so that the elevator always can provide at least 1.2g of nose-up pitch authority to enable the flight crew to recover from a nose-low attitude. Second, if the pilots make electric pitch trim inputs to counter the MCAS, it won’t reset after 5 sec. and repeat subsequent nose-down stab trim commands. And third, if the MCAS nose-down stab trim input exceeds limits programmed into the new FCC software, it triggers a maintenance message in the onboard diagnostics system.



Pilots during their sim training they had never been exposed to extreme and continuous AOA indication errors, they’ve not experienced AOA induced airspeed and altitude deviations on PFDs and have not had to deal with continuous stall-warning stickshaker distractions. 

They also note that they have never been required to fly the aircraft from the point at which a runaway stab trim incident occurred all the way to landing using only the manual trim wheels. “We’re just checking boxes for the FAA".

Nenhum comentário:

Postar um comentário